Houses · cabins · off-grid
Know what's in the tank without lifting the lid
Fresh water, waste water, rainwater, heating oil — the tanks around a house are buried or tucked out of sight. Gobius mounts on the outside and puts the real volume on your phone, so you book the emptying or filling before it is urgent. Your tank can be 4.5 m deep.
- Reads from outside
- Never touches the contents
- About 15 minutes to fit
The problem
You cannot see into a buried tank
There is no window and no gauge — just a heavy lid, a torch and a stick, or waiting until the tank tells you itself.
A septic tank says it is full by backing up indoors. A cabin water tank says it is empty halfway through a shower. A number on your phone avoids both.

Around a house or cabin
Four tanks worth watching
Same sensor, same idea: it reads through the tank wall from the outside and shows the volume or level in your phone's app.
Waste holding tanks
Watch it pass 70%, 80%, 90%, and book the emptying while it is a diary entry, not an emergency.
Drinking & well water
At a cabin off the mains, see how many days of water are left rather than finding out when the pump does.
Rainwater
See what a wet week actually collected, and when to switch back to mains for watering and washing.
Heating oil
Oil goes down slowly and runs out in January. See the volume on your phone to order in time.
Fitting it
Fit it once, then forget it
- 01
Reach the tank
A buried tank still has to be reachable, usually through the inspection chamber. Gobius C needs the tank top, Gobius Pro a side wall.
- 02
Fit the sensor
It goes on the outside and reads through the wall. Nothing is drilled on polyethelene or fibreglass. About 15 minutes.
- 03
Set it up in the app
Run through the installation once, set your alarm levels, and that is it.
Most houses use Gobius C: radar on the tank top, stepless 0–100 %. Gobius Pro glues to a side wall, reads any material including metal, and gives one fixed alarm point per sensor — which can switch a lamp, buzzer or pump. Compare them.
No maintenance
Nothing goes in the tank
| Where it sits | Outside the tank — top face (Gobius C) or side wall (Gobius Pro) |
|---|---|
| Drilling | None on polyethelene or fibreglass — the usual domestic tank |
| What you see | 0–100 % and 2 alarms in the Gobius C app |
| Fits | Tanks, 200–4500 mm deep, holding water, waste, oil, any fluids |
| Power | 12–24 V DC · IP 66 |
| Maintenance | None, ever |
The app reads the sensor over Bluetooth, so you check the tank when you are there — no cloud service. Installation guides.
Get started
One sensor per tank
Start with the tank that worries you most and add the others later — all of them in the same app.

Gobius C, Basic, 0-100%
Plug and play installation. No disassembly of the tank is needed. Measures from the top, never risk of leakage. Complete system, everything included; sensor, 2 m cable, Quick Guide and a 3M cleaning wipe. Handles voltage of 12-24 Volts.…

Gobius C, NMEA 2000, 0-100%
Plug and play installation. Can be connected direct to a NMEA 2000 networks. No disassembly of the tank is needed. Measures from the top, never risk of leakage. Complete system, everything included; sensor, NMEA 2000 cable, 3M cleaning…

Sensor tape kit, Gobius and Gobius Pro
Useful for attaching Gobius and Gobius Pro sensors on the tank. Can't be used for Gobius C sensors.

Gobius C, all analog outputs, 0-100%
Plug and play installation. No disassembly of the tank is needed. Measures from the top, never risk of leakage. Complete system, everything included; sensor, cable, 3M cleaning wipe. Handles voltage of 12-24 Volts. The sensor is mounted in…

Gobius C adapter for metal tanks

Gobius Pro with 1 sensor
Measuring from the outside the tank, nothing on the inside. Bluetooth and App for your phone included.

Gobius Pro with 2 sensors
Measuring from the outside the tank, nothing on the inside. Bluetooth and App for your phone included.

Gobius Pro with 3 sensors
Measuring from the outside the tank, nothing on the inside. Bluetooth and App for your phone included.

Gobius 4 for grey, black & waste tanks
Complete tank monitor system for grey, black and waste tanks, version 5.0.

Gobius 4 for water/fuel- & fluid tanks
Complete tank monitor system for water, fuel and other fluids.

Upgrade Gobius 1 to Gobius 4, grey, black & waste tanks
For waste tanks

Upgrade Gobius 1 to Gobius 4 for water/fuel- & fluid tanks
For water/fuel- & fluid tanks, version 5.0.

Gobius C, analog cable, 1 m, 8 pins (male)

Gobius C, NMEA 2000 cable, 1 m, 12 pins (female)

Gobius panel cable, 1,5 m
Used to connect the panel to the Control unit.

New Control unit for Gobius 1 and 4 for grey, black & waste tanks
Control unit for Gobius 1 and Gobius 4, Waste tanks, version 5.0.

Upgrade your old Gobius to version 5.0
Step up to the version 5.0 of Gobius 4, Waste or Water/Fuel/Fluid.

New Control unit for Gobius 1 and 4 for water/fuel- & fluid tanks
Control unit for water/fuel- & fluid tanks, version 5.0.
Gobius panel cable, 5 m
Used to connect the Panel to the Control unit.

Gobius panel cable, 10 m
Used to connect the panel to the Control unit.

Analog cable, 0,5 m
Complete cable

NMEA 2000 Converter
Converts tank data from Gobius and Gobius Pro to NMEA 2000 networks.

Gobius sensor with 1 m cable
1 meter cable lenght

Gobius panel (PIR)
Smart overfill alarm panel with built-in motion sensor (PIR). Starts Gobius when you visit the toilet and switches off automatically after 60 seconds. Alarms when the waste tank is full. Only 12 Volt.

Gobius panel for grey, black & waste tanks
For Gobius 1 and 4, grey, black & waste tanks.

Gobius panel for water/fuel- and fluid tanks
For Gobius 1 and 4, for water/fuel- and fluid tanks.

Hub for Gobius Pro sensors
Out signals: 10-180 Ohm and 240-33 Ohm. Read more about the Hub at Gobiuspro.com, Documentation.

Audible alarm, buzzer
Suitable for all Gobius products, (version 3.0, 4.0 and 5.0) and also for Gobius Pro sensors.
Not sure what your tank needs? Send us a photo and a rough size — we answer every day.
Questions
What homeowners ask
My tank is buried. Does that work?
Yes, provided the tank can be reached — usually through the inspection chamber. The sensor mounts on the tank, so you need that access once, at fitting.
Do I have to drill the tank?
Not on polyethelene or fiberglass: both sensors work from the outside, with the tank sealed and full. Metal is the one exception for Gobius C — radar cannot pass through it, so a metal tank needs a small port in the top. Gobius Pro reads metal from the side with nothing drilled. More in no-drill installations.
Will the reading drift over the years?
Floats and probes sit in the liquid and coat over. There is nothing in there to coat, so year five reads like day one. Full FAQ.
Stop guessing what's in the tank
Fit it once and check the volume and level from the kitchen table instead of the lawn. Designed in Sweden.